View source for Beagleboard Black Wireless

=Basic connecting=
Initial Internet access to upgrade and install additional packages. (Connect to open WiFi AP) 
<source lang=cli>
iwconfig wlan0 essid Wifi6D50_GUEST
iwconfig wlan0  
wlan0     IEEE 802.11  ESSID:"Wifi6D50_GUEST"
          Mode:Managed  Frequency:2.412 GHz  Access Point: 72:D4:53:3F:6D:57
          Bit Rate=144.4 Mb/s   Tx-Power=20 dBm
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=63/70  Signal level=-47 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0
dhclient wlan0
ifconfig wlan0
wlan0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        inet 192.168.2.126  netmask 255.255.255.0  broadcast 192.168.2.255
        ether 38:d2:69:d5:dc:3d  txqueuelen 1000  (Ethernet)
        RX packets 136  bytes 7764 (7.5 KiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 16  bytes 3540 (3.4 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
</source>
==Updating and installing WLAN tools==
<source lang=cli>
apt install wpasupplicant
</source>
==Connect to WPA==
Example content of ''/etc/network/interfaces''
<source lang=bash>
# interfaces(5) file used by ifup(8) and ifdown(8)
# Include files from /etc/network/interfaces.d:
source /etc/network/interfaces.d/*
auto wlan0
iface wlan0 inet dhcp
        wpa-key-mgmt WPA-PSK
        wpa-group TKIP CCMP
        wpa-ssid "MYSSID"
        wpa-psk "MYPASSCODE"
</source>
'''Remember:''' To secure file
<source lang=bash>
chmod 600 /etc/network/interfaces
</source>

==Connect to WPA2 Enterprise==
/etc/wpa_supplicant/acme.conf
<source lang=bash>
## Connect to a WPA2 Enterprise network using this command:
## wpa_supplicant -B -i wlan0 -c /etc/acme.conf
## Then run dhclient wlan0 to get an IP Address
network={
scan_ssid=1
eap=PEAP
ssid="MYSSID"
key_mgmt=WPA-EAP
identity="MYNAME"
password="MYPASSCODE"
phase1="peaplabel=0"
phase2="auth=MSCHAPV2"
}
</source>
=Links=
*[https://7thzero.com/blog/wifi-from-the-cli-in-linux-using-wpa_supplicant Setup a WPA2-Enterprise connection]
*[https://www.fis.gatech.edu/how-to-configure-bbw-wifi/ Wireless Getting Started] (Best) 
*[https://linuxconfig.org/how-to-connect-to-wifi-from-the-cli-on-debian-10-buster Wireless Getting Started]
[[Category:Beagleboard Black]]