Difference between revisions of "JLab Server"
From Teknologisk videncenter
m (→EtherChanel) |
m (→EtherChanel) |
||
Line 6: | Line 6: | ||
==EtherChanel== | ==EtherChanel== | ||
Nic Bonding på Ubuntu er beskrevet her: https://help.ubuntu.com/community/LinkAggregation | Nic Bonding på Ubuntu er beskrevet her: https://help.ubuntu.com/community/LinkAggregation | ||
+ | <pre> | ||
+ | sudo aptitude install ifenslave | ||
+ | </pre> | ||
+ | sudo nano /etc/network/interfaces | ||
+ | <pre> | ||
+ | # This file describes the network interfaces available on your system | ||
+ | # and how to activate them. For more information, see interfaces(5). | ||
+ | |||
+ | # The loopback network interface | ||
+ | auto lo | ||
+ | iface lo inet loopback | ||
+ | |||
+ | # The primary network interface | ||
+ | auto eth0 | ||
+ | iface eth0 inet dhcp | ||
+ | # This is an autoconfigured IPv6 interface | ||
+ | iface eth0 inet6 auto | ||
+ | |||
+ | #Create the interface | ||
+ | auto bond0 | ||
+ | iface bond0 inet static | ||
+ | address 10.0.0.1 | ||
+ | netmask 255.255.255.0 | ||
+ | #Add physical network adapters | ||
+ | bond-slaves eth1 eth2 | ||
+ | #Configure load balancing mode | ||
+ | #mode=0 (balance-rr) | ||
+ | #mode=1 (active-backup) | ||
+ | #mode=2 (balance-xor) | ||
+ | #mode=3 (broadcast) | ||
+ | #mode=4 (802.3ad) | ||
+ | #mode=5 (balance-tlb) | ||
+ | #mode=6 (balance-alb) | ||
+ | |||
+ | bond_mode 2 | ||
+ | |||
+ | </pre> | ||
==VLans== | ==VLans== |
Revision as of 11:00, 22 December 2011
<accesscontrol>teacher</accesscontrol>
Ide
Ideen med denne server er at lave et Juniper Lab, med en logon server der giver kursisten adgang til et virtuelt netværk hvor der kan opsættes udstyr og prøves ting af i et test senarie.
Installation
EtherChanel
Nic Bonding på Ubuntu er beskrevet her: https://help.ubuntu.com/community/LinkAggregation
sudo aptitude install ifenslave
sudo nano /etc/network/interfaces
# This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface auto eth0 iface eth0 inet dhcp # This is an autoconfigured IPv6 interface iface eth0 inet6 auto #Create the interface auto bond0 iface bond0 inet static address 10.0.0.1 netmask 255.255.255.0 #Add physical network adapters bond-slaves eth1 eth2 #Configure load balancing mode #mode=0 (balance-rr) #mode=1 (active-backup) #mode=2 (balance-xor) #mode=3 (broadcast) #mode=4 (802.3ad) #mode=5 (balance-tlb) #mode=6 (balance-alb) bond_mode 2
VLans
Vlan konfiguration står beskrevet her: http://www.mysidenotes.com/2007/08/17/vlan-configuration-on-ubuntu-debian/