Latest revision as of 21:14, 4 November 2014

Multicast

This page is part of the Netband Project

• A multicast server is installed on the server HQDC1

Configuration

• Switch
• Only configuration from HQSW1 is shown, as the configuration on B1SW1 is identical

ip multicast-routing distributed
!
interface FastEthernet0/24
 description HQrt1
 no switchport
 ip address 10.255.255.1 255.255.255.252
 ip pim sparse-dense-mode
 ip ospf network point-to-point
 ip ospf dead-interval minimal hello-multiplier 4
!
interface Vlan3
 ip address 10.1.1.1 255.255.255.0
 ip pim sparse-dense-mode
!
ip pim rp-address 10.0.0.12

• Routers
• Only configuration from HQSRT1 is shown, as the configuration on B1RR1 is identical

ip multicast-routing
!
interface Tunnel0
 ip address 10.255.254.1 255.255.255.252
 ip mtu 1300
 ip pim sparse-dense-mode
 ip virtual-reassembly
 tunnel source Loopback1
 tunnel destination 10.255.253.2
!
interface FastEthernet0/1
 description HQSW1
 ip address 10.255.255.2 255.255.255.252
 ip pim sparse-dense-mode
 ip nat inside
 ip virtual-reassembly
 ip ospf network point-to-point
 ip ospf dead-interval minimal hello-multiplier 4
 duplex auto
 speed auto
!

Verification

B1sw1#sh ip mroute
...
(10.1.1.11, 239.0.0.40), 00:11:05/00:02:54, flags: JT
  Incoming interface: FastEthernet0/2, RPF nbr 10.255.255.14
  Outgoing interface list:
    Vlan5, Forward/Sparse, 00:11:05/00:02:48

• Vlc is used as a the stream client

Åben the multicast stream

Streaming

Link

Use iPerf as the multicast sender and listener

• https://gist.github.com/jayjanssen/5697813