Difference between revisions of "XBMC on Raspbian"
From Teknologisk videncenter
m |
m |
||
| (One intermediate revision by the same user not shown) | |||
| Line 15: | Line 15: | ||
#Enable it on the next reboot | #Enable it on the next reboot | ||
echo ipv6 >> /etc/modules | echo ipv6 >> /etc/modules | ||
| + | </source> | ||
| + | If you overclock then use this tool to watch the temperature<ref>http://www.elinux.org/RPI_vcgencmd_usage</ref>: | ||
| + | <source lang=bash> | ||
| + | pi@raspberrypi ~ $ /opt/vc/bin/vcgencmd measure_temp | ||
| + | temp=47.6'C | ||
</source> | </source> | ||
Now follow [http://www.raspbian.org/RaspbianXBMC this] link from step 4. | Now follow [http://www.raspbian.org/RaspbianXBMC this] link from step 4. | ||
Latest revision as of 19:06, 21 November 2012
Download and install the lastest raspbian to a SD card and boot it on the Raspberry.
Configure it without Window manager, with SSH, 16 MB GPU RAM Overclocking at 950 and the correct timezone and expand the rootfs.
Install the rpi-update to update the firmware and so on
apt-get update
apt-get install git-core
wget http://goo.gl/1BOfJ -O /usr/bin/rpi-update && sudo chmod +x /usr/bin/rpi-update
rpi-update
rebootEnable IPv6 on the PI
# enable it on the fly
modprobe ipv6
#Enable it on the next reboot
echo ipv6 >> /etc/modulesIf you overclock then use this tool to watch the temperature[1]:
pi@raspberrypi ~ $ /opt/vc/bin/vcgencmd measure_temp
temp=47.6'C