Difference between revisions of "CCNP SWITCH/Implementing Inter-VLAN Routing"
m (→Inter-VLAN Routing) |
m (→Router-on-a-Stick) |
||
| Line 42: | Line 42: | ||
*Trunk link may be congested when multible VLANs use it. | *Trunk link may be congested when multible VLANs use it. | ||
*Latency might be higher as frames leave and re-enter the switch chassis multiple times and the router makes software-based routing decisions. | *Latency might be higher as frames leave and re-enter the switch chassis multiple times and the router makes software-based routing decisions. | ||
| + | ==Inter-VLAN Routing Using SWI== | ||
Revision as of 09:31, 29 August 2011
This article is under development....Inter-VLAN Routing
Because VLANs isolate trafficto a defined broadcast domain and subnet, network devices in different VLANs cannot communicate with each other natively.
Adding an external routing with subinterface routing does not scale beyond 50 VLANs. Cisco IOS routers only support trunking in IP Plus Feature set and above.
Catalyst Multilayer Switches support 3 different routed interface types:
- Routed Port
- A pure Layer 3 interface similar to a routed port on a Cisco IOS router.
- Switched Virtual Interface (SVI)
- A virtual VLAN interface for inter-VLAN routing. In other words, SVIs are the virtual routed VLAN interfaces.
- Bridged Virtual Interfaces (BVI)
- A Layer 3 virtual bridging interface.
All Cisco Layer 3 Switches support routing protocols, but several models requires enhanced software for specific routing protocol features.
To change between routed and switchports use no switchport and switchport interface commands respectively. Catalyst 6500 switches use L3 interfaces by default, so depending on the switching model the swithport and no switchport command might be present in the running-config files.
| Switch Type | Inter-VLAN Routing Capability | Inter-VLAN Routing Solution |
|---|---|---|
| Catalyst 2940/2950/2955/2960/2970 | No | N/A |
| Catalyst 3560/3750/3760 | Yes | Integrated |
| Catalyst 4000/4500/4948 | Yes | Catalyst 4000 running Cisco CatOS with Supervisor I or II, using the Layer 3 module, WS-X4232-L3 Catalyst 4000 with a Supervisor II+, III, IV, or V running Cisco IOS using integrated routing |
| Catalyst 6500 | Yes | Catalyst 6500 with an MSFC, MSFC II, or MSFC III daughter card running Cisco CatOS on the supervisors and Cisco IOS on the MSFC Catalyst 6500 with MSFC, MSFC II, or MSFC III running Cisco Native IOS Catalyst 6500 using a legacy MSM module |
Router-on-a-Stick
Router-on-a-Stick Advantages and Disanvantages
- Works on any L2 switch that support Trunking.
- Simpel Implementation. Only one swithc port and one router interface require configuration.
- The Router provides Inter-VLAN Routing i a Layer 2 network.
- The Router is a single point of failure.
- Trunk link may be congested when multible VLANs use it.
- Latency might be higher as frames leave and re-enter the switch chassis multiple times and the router makes software-based routing decisions.