Difference between revisions of "Mdp ccnp 1"

From Teknologisk videncenter
Jump to: navigation, search
(IS-IS Noter)
(IS-IS Noter)
Line 38: Line 38:
  
 
Ip router isis [area-tag] enable isis on the interface that run isis (this approach is slightly different than most IP routing protocols,
 
Ip router isis [area-tag] enable isis on the interface that run isis (this approach is slightly different than most IP routing protocols,
where the interface are defined by network statements; there is no network statement under the isis process.) Given in interface configuration mode.
+
where the interface are defined by network statements; there is no network statement under the isis process.) Given in interface  
 +
 
 +
configuration mode.
  
 
</pre>
 
</pre>

Revision as of 10:23, 17 February 2009

CCNP 1

Ospf Challange Lab Noter

Hvis man skal lave en restribute mellem OSPF og EIGRP, skal man sætte en default metric på EIGRP siden. Kommandoen man skal bruge ser sådan ud:

router eigrp 65000
 redistribute ospf 1 metric 1000 10 255 255 1500

IS-IS Noter

IS-IS and OSPF are more similar than dissimilar. Both routing protocols have the following characteristics:

  • Open-standard link-state routing protocols
  • Support VLSM
  • Support route summarization between areas
  • Similar mechanisms to maintain the health of the LSDB (link-state advertisements [LSAs], link-state aging timers,and LSDB synchronization)
  • Use the shortest path first (SPF) algorithm, with similar update, decision, and flooding processes
  • Successful in the largest and most demanding ISP networks
  • Converge quickly after network changes

The basic setup of IS-IS requires four steps.

  • Step 1 Map out the areas, plan the addressing, and determine which interfaces are to participate in the IS-IS routing process.
  • Step 2 Enable IS-IS on the router with the router isis global configuration command.
  • Step 3 Configure the NET address with the net router configuration command.
  • Step 4 Enable Integrated IS-IS on the appropriate interfaces with the ip router isis interface configuration command.

Commands to do this

router isis [area-tag] enable isis as an IP routing protocol and assigns a tag to the process (optional). Given en global configuration mode.

net network-entity-title Identifies the router for isis by assigning a net to the router. Given in global configuration mode.

Ip router isis [area-tag] enable isis on the interface that run isis (this approach is slightly different than most IP routing protocols,
where the interface are defined by network statements; there is no network statement under the isis process.) Given in interface 

configuration mode.