Difference between revisions of "BO CCNA Course/coursematerials/Frame Relay Setup"
From Teknologisk videncenter
m (Created page with "Configure the following setup in Packet Tracer {| |800px|left|thumb|Setup |} ==Tasks== #Drag a Generic WAN emulation cloud into the working area #Con...") |
(No difference)
|
Revision as of 10:53, 21 August 2012
Configure the following setup in Packet Tracer
Tasks
- Drag a Generic WAN emulation cloud into the working area
- Configure serial 0 with a DLCI of 102 and name HQ-Dallas
- Configure serial 1 with a DLCI of 201 and name Dallas-HW
- Create a Frame Relay mapping as shown in Fig. 4
- Connect the Routers and end devices in Cisco Packet Tracer as shown in the topology
- Configure hostname and basic setup on all routers.
- Configure IP addresses on the serial connections
- HQ Router should use the first usable IP address in the range
- Dallas Router should have the last usable IP address in the range
What LMI protocol is used on the Serial connection?
Are the 2 router able to ping each other?
- Configure the LAN interface with the first usable IP address in the range
- Configure the hosts with the last usable IP address in the range.
- Configure OSPF on the 2 Routers
- Disable LMI and create static Frame Relay maps
Is Routing working as expected?
- Use some of the show commands you know to verify Frame Relay connectivity