Difference between revisions of "ITT 2013/Network module 1/Assignment Day 12"
From Teknologisk videncenter
< ITT 2013 | Network module 1
m (→Setup) |
m (→Dynamic NAT) |
||
| Line 21: | Line 21: | ||
##Configure outside interface | ##Configure outside interface | ||
##Configure ACL (ip access-list 1 permit 10.0.0.0 0.0.255.255) | ##Configure ACL (ip access-list 1 permit 10.0.0.0 0.0.255.255) | ||
| − | ##Configure a NAT pool | + | ##Configure a NAT pool(Including the addresses 193.80.112.40 - 45) |
##Configure dynamic NAT | ##Configure dynamic NAT | ||
| + | |||
==Static NAT== | ==Static NAT== | ||
In this setup we will add a static NAT to the previous configuration | In this setup we will add a static NAT to the previous configuration | ||
Revision as of 09:09, 29 October 2013
Setup
Configure the following in Packet Tracker
Dynamic PAT
- Configure IP addresses on all routers
- Configure IP addresses on all hosts
- Configure NAT
- Configure inside interface
- Configure outside interface
- Configure ACL (ip access-list 1 permit 10.0.0.0 0.0.255.255)
- Configure dynamic PAT
- Configure static PAT/Port forwarding
Dynamic NAT
In this setup we need some more public ip addresses so we are going to change the /30 network on the outside to a /28. This will allow us to have 12 translatable addresses.
- Delete all NAT configuration
- Change the outside subnet from /30 to /28
- Configure NAT
- Configure inside interface
- Configure outside interface
- Configure ACL (ip access-list 1 permit 10.0.0.0 0.0.255.255)
- Configure a NAT pool(Including the addresses 193.80.112.40 - 45)
- Configure dynamic NAT
Static NAT
In this setup we will add a static NAT to the previous configuration
- Configure static NAT statement, translating the public address of 193.80.112.35 to 10.0.100.100