Revision as of 11:34, 29 October 2013

Setup

Image text

IPv4

The task is now to configure IPv4 in the setup. And make sure all the devices can ping each other.

IPv4 Connectivity

• Configure all the IPv4 addresses in the setup.
  • The lowest IP address should be configured on the router with the lowest router number, on the interface.
• Make sure you can ping all the neighbour interfaces

Commands

interface FastEthernet0/0
 ip address 10.0.0.1 255.255.255.0
 no shutdown
!
interface Serial0/0/0
 ip address 192.168.0.1 255.255.255.252
 no shutdown
!
interface Serial0/0/1
 ip address 192.168.0.9 255.255.255.252
 no shutdown

R1#<input>ping 192.168.0.2</input>

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.0.2, timeout is 2 seconds:
!!!!!
<notice>Success rate is 100 percent (5/5)</notice>, round-trip min/avg/max = 1/8/13 ms

R1#

IPv4 RIP

• Configure RIPv2 on all the devices
• Disable auto-summarization on RIP

IPv6

We now need to configure IPv6 addresses and routing in the setup to create a Dual-Stack network.

IPv6 Connectivity

• Configure IPv6 addresses on all the interfaces
• Make sure you can ping the neighbour interfaces

IPv6 RIP

• Configure RIPng on all the interfaces