Difference between revisions of "ITT 2014/Network module 1/Assignment Day 3"
From Teknologisk videncenter
< ITT 2014 | Network module 1
m (Created page with "=Routing= Implement the following setup in Packet Tracer. <br/> Use the WIC interface calles WIC-2T in the 1841 Router<br/>With the following interface configuration:<br/> <sourc...") |
m (→Routing) |
||
| Line 1: | Line 1: | ||
=Routing= | =Routing= | ||
Implement the following setup in Packet Tracer. <br/> | Implement the following setup in Packet Tracer. <br/> | ||
| − | Use the WIC interface | + | Use the WIC interface called WIC-2T in the 1841 Router<br/>With the following interface configuration:<br/> |
<source lang=cli> | <source lang=cli> | ||
Router#<input>conf t</input> | Router#<input>conf t</input> | ||
Revision as of 13:44, 1 September 2014
Routing
Implement the following setup in Packet Tracer.
Use the WIC interface called WIC-2T in the 1841 Router
With the following interface configuration:
Router#<input>conf t</input>
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#<input>int se 0/0/0</input>
Router(config-if)#<input>ip add 192.168.1.6 255.255.255.252</input>
Router(config-if)#<input>no shut</input>
Implement it using RIPv2
Create a static default route pointing to the cloud:
Router(config)#<input>ip route 0.0.0.0 0.0.0.0 192.168.1.17</input>If you need information on configuring basics on Cisco IOS devices read Chapter 2 in the CCNA Routing & Switching online book.
Or look at this slide on Chapter 2
Configuration Guide
Follow this guide to make it work.
Subnetting
Calculate the missing information until you feel comfortable