Difference between revisions of "Netband Project - IP Source Guard"
From Teknologisk videncenter
(→Configuration) |
(→Configuration) |
||
Line 23: | Line 23: | ||
Source IP address verification | Source IP address verification | ||
<pre> | <pre> | ||
− | + | interface FastEthernet0/10 | |
ip verify source | ip verify source | ||
</pre> | </pre> |
Revision as of 13:12, 14 April 2009
<accesscontrol>NetBand</accesscontrol> This page is part of the Netband Project
- IP source guard is a security feature that restricts IP traffic on nonrouted, Layer 2 interfaces by filtering traffic based on the DHCP snooping binding database and on manually configured IP source bindings. You can use IP source guard to prevent traffic attacks caused when a host tries to use the IP address of its neighbor.
- IP source guard is supported only on Layer 2 ports, including access and trunk ports
- An ACL is applied to the interface, which allows only IP traffic with a source IP address in the IP source binding table and denies all other traffic.
- Filtering options
- Source IP address
- The switch forwards IP traffic when the source IP address matches an entry in the DHCP snooping binding database or a binding in the IP source binding table.
- Source IP and MAC Address
- The switch forwards traffic only when the source IP and MAC addresses match an entry in the IP source binding table.
- Filters both ip and non-ip traffic
- Port security is used to filter source MAC addresses
- Is not supported on pvlan
- Source IP address
Configuration
Source IP -and Mac address verification
interface FastEthernet0/10 ip verify source port-security
Source IP address verification
interface FastEthernet0/10 ip verify source