BO CCNA Course/coursematerials/RIP Router Setup
From Teknologisk videncenter
< BO CCNA Course | coursematerials
Revision as of 20:22, 28 May 2012 by Rael (talk | contribs) (Created page with "=Setup= Connect the following equipment in Packet Tracer {| |800px|left|thumb|Network Setup |} =Tasks= #Create Labels indicating the different netw...")
Setup
Connect the following equipment in Packet Tracer
Tasks
- Create Labels indicating the different networks
- Document the IP addresses assigned to the devices using Labels
- Do a basic Router configuration
- Configure hostname
- Configure an enable password
- Configure a VTY password
- Configure a Console password
- Enable password encryption
- Set a loggin banner
Use the show commands you know to verify Layer1+2 connectivity?
- Configure IP addresses
- The Lowest IP address should be assigned to the Router on each LAN segment
- The DCE Router should use the lowest IP address on each Serial line
- The DTE Router should use the highest IP address on each Serial line
Are all the end devices able to ping their Default Gateway?
Are all the Routers able to ping their neighbours?
Are all the end devices able to ping the other end devices?
- Configure static routing - part 1
- Configure static routing on all the Router for the 192.168.1.0/24 & 192.168.2.0/24 network
Are all the end devices able to ping the other end devices?
- Configure static routing - part 2
- Configure complete static routing on all the router to all the networks
Are all the end devices able to ping the other end devices?
- Delete the static routes on the routers and replace them with summary routes for the 172.16 & the 192.168 networks