View source for BO CCNA Course/coursematerials/RIP Router Setup

=Setup=
Connect the following equipment in Packet Tracer
{|
|[[Image:ScreenShot1244.jpg|800px|left|thumb|Network Setup]]
|}

=Tasks=

#Create Labels indicating the different networks
#Document the IP addresses assigned to the devices using Labels
#Do a basic Router configuration
##Configure hostname
##Configure an enable password
##Configure a VTY password
##Configure a Console password
##Enable password encryption
##Set a loggin banner
<br/>
'''Use the show commands you know to verify Layer1+2 connectivity?'''<br /><br /> 
#Configure IP addresses
##The Lowest IP address should be assigned to the Router on each LAN segment
##The DCE Router should use the lowest IP address on each Serial line
##The DTE Router should use the second IP address on each Serial line
##Connect a PC to all the end networks, and give it the .10 IP address
<br/>
'''Are all the end devices able to ping their Default Gateway?'''<br /><br />
'''Are all the Routers able to ping their neighbours?'''<br /><br />
#Configure RIPv1 routing
##Enable '''debug ip rip''' on the routers as you enable RIP
##Configure the '''network''' statement on all the connected networks. Remember: only use the classfull network
##Verify the routing table on all the routers
##Disable debuging
<br/>
'''What is the network address R2 propagetes to R3?'''<br /><br /> 
'''Do the routers support receiving RIPv2 packets?'''<br /><br />  
'''Do all the routers see all the networks with the correct network mask?'''<br /><br />
'''Are all the end devices able to ping the other end devices?'''<br /><br /> 
#Configure RIPv2 Routing
##Enable '''debug ip rip''' on the routers as you enable RIPv2 
##Configure all the routers to use RIPv2
<br/>
'''Why does R2 still propagate the classfull 172.30.0.0/16 network to R3?'''<br /><br />
#Configure the routers to disable auto summerization at the boundary router
<br/>
'''Do you now have the expected routing table?'''<br /><br />
#Loopback Interfaces
##Subnet the 10.240.0.0/23 into 8 smaller subnets with 62 host addresses on each
##Assign the lowest addres on the first 4 subnets to 4 Loopback interfaces on R1
##Assign the lowest addres on the highest 4 subnets to 4 Loopback interfaces on R3
##Add all the Loobpack interfaces to RIP
<br/>
'''Do a debug - Is RIP sending updates on the Loopback interfaces?'''<br /><br />
#Disable updates on the Loopback interfaces
<br/><br/>
#Move 3 of the Loopback interfaces with theire network from R3 to R1
#Create a summary route for the entire 10.240.0.0/23 on R1 and redistribute it into RIP
<br/>
'''Now take a look at the routing table on R3'''<br /><br /> 
[[Category:Cisco]]
[[Category:CCNA]]