Difference between revisions of "Stateless Autoconfiguration IPv6"
From Teknologisk videncenter
m (New page: Stateless Autoconfiguration means that the node will attempt to Configure it's own IPv6 Address) |
m |
||
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Stateless Autoconfiguration means that the [[Configuring IPv6 addresses#Terminology|node]] will attempt to Configure it's own [[IPv6 Address]] | + | Stateless Autoconfiguration - SLAAC - means that the [[Configuring IPv6 addresses#Terminology|node]] will attempt to Configure it's own [[IPv6 Address]] based on [[EUI-64]] or Randomly. Stateless Autoconfiguration uses [[ICMPv6]]. |
| + | *Statless Autoconfiguration is described in these [[IPv6_notes#ICMPv6|RFC's]] | ||
| + | =Implementations= | ||
| + | *[[Stateless Autoconfiguration IPv6 Cisco IOS]] | ||
| + | [[Category:IPv6]] | ||
Latest revision as of 16:46, 11 May 2014
Stateless Autoconfiguration - SLAAC - means that the node will attempt to Configure it's own IPv6 Address based on EUI-64 or Randomly. Stateless Autoconfiguration uses ICMPv6.
- Statless Autoconfiguration is described in these RFC's