Difference between revisions of "Ip linux command"
From Teknologisk videncenter
m (→Adding IP addresses) |
m (→References) |
||
| Line 74: | Line 74: | ||
--> | --> | ||
| + | =Links= | ||
| + | *[https://access.redhat.com/sites/default/files/attachments/rh_ip_command_cheatsheet_1214_jcs_print.pdf IP command Cheat Sheet] | ||
=References= | =References= | ||
<references/> | <references/> | ||
{{Source cli}} | {{Source cli}} | ||
[[Category:network]][[Category:Linux]][[Category:Linux Command]] | [[Category:network]][[Category:Linux]][[Category:Linux Command]] | ||
Latest revision as of 09:22, 16 May 2017
Introduction to the linux ip[1].
Function: show / manipulate routing, devices, policy routing and tunnels
Contents
Basic IPv4
Show route table
heth@mars:~$ <input>ip route</input>
172.16.4.0/24 dev eth0 proto kernel scope link src 172.16.4.17
192.168.139.0/24 via 172.16.4.19 dev eth0
192.168.0.0/16 via 172.16.4.21 dev eth0
172.16.0.0/12 via 172.16.4.21 dev eth0
10.0.0.0/8 via 172.16.4.21 dev eth0
default via 172.16.4.16 dev eth0 metric 100Show interface device
heth@mars:~$ <input>ip addr show eth0</input>
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen 1000
link/ether 00:14:5e:67:61:4a brd ff:ff:ff:ff:ff:ff
inet 172.16.4.17/24 brd 172.16.4.255 scope global eth0Adding IP addresses
root@mars:~# <input>ip addr add 17.30.5.65/24 dev eth1</input>
root@mars:~# <input>ip addr add 17.30.6.65/24 dev eth1</input>
root@mars:~# <input>ip addr show eth1</input>
3: eth1: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN qlen 1000
link/ether 00:14:5e:67:61:4b brd ff:ff:ff:ff:ff:ff
inet 17.30.5.65/24 scope global eth1
inet 17.30.6.65/24 scope global eth1Deleting IP addresses
root@mars:~# <input>ip addr del 17.30.6.65/24 dev eth1</input>Adding a route
root@mars:~# <input>ip route add 172.31.9.0/24 via 172.16.4.16 dev eth0</input>
root@mars:~# <input>ip route add 172.31.10.0/24 via 172.16.4.16</input>Deleting a route
root@mars:~# <input>ip route del 172.31.9.0/24 via 172.16.4.16 dev eth0</input>
root@mars:~# <input>ip route del 172.31.10.0/24 via 172.16.4.16</input>Adding a virtual router
Adding a virtual router between eth1 and eth2 and using NAT.
- Outside: eth1 ip addr 204.0.0.34/28
- Inside: eth2 ip addr 172.21.0.201/16
The script could be added to /etc/rc.local
echo "1" > /proc/sys/net/ipv4/ip_forward
ip route flush table 4
ip rule del fwmark 4 table 4
iptables -F -t nat
iptables -F -t mangle
ip route add table 4 204.0.0.32/28 dev eth1 scope link
ip route add table 4 172.21.0.0/16 dev eth2 scope link
ip route add table 4 172.22.0.0/16 dev eth2 via 172.21.0.2
ip route add table 4 default via 204.0.0.33
iptables -t mangle -A PREROUTING -s 172.21.0.0/16 -d 0/0 -j MARK --set-mark 4
iptables -t mangle -A PREROUTING -s 172.22.0.0/16 -d 0/0 -j MARK --set-mark 4
ip rule add fwmark 4 table 4
iptables -t nat -A POSTROUTING -s 172.21.0.0/16 --mark 4 -d 0/0 -j SNAT --to 204.0.0.34
iptables -t nat -A POSTROUTING -s 172.22.0.0/16 --mark 4 -d 0/0 -j SNAT --to 204.0.0.34- Note
- the --mark i iptables POSTROUTING needs verification