Difference between revisions of "Cluster der kan alt/Routning og NAT"
m (→Routning & NAT) |
m (→Start Routing) |
||
| Line 3: | Line 3: | ||
==Start Routing== | ==Start Routing== | ||
| − | For this, we do not need to install anything new. Everything is right there but is currently disabled. First, edit /etc/sysctl.conf. Find this: | + | For this, we do not need to install anything new. Everything is right there but is currently disabled. First, edit '''/etc/sysctl.conf'''. Find this: |
<source lang=cli> | <source lang=cli> | ||
net.ipv4.ip_forward=1 | net.ipv4.ip_forward=1 | ||
| Line 13: | Line 13: | ||
</source> | </source> | ||
This will enable it without a reboot. | This will enable it without a reboot. | ||
| + | |||
==NAT== | ==NAT== | ||
<source lang=cli> | <source lang=cli> | ||
Revision as of 13:29, 18 April 2012
Routning & NAT
Configuring NAT (Sharing Internet)
Start Routing
For this, we do not need to install anything new. Everything is right there but is currently disabled. First, edit /etc/sysctl.conf. Find this:
net.ipv4.ip_forward=1Uncomment it by removing the #. Now forwarding is enabled in the system kernel.
Start routing without a reboot
echo 1 > /proc/sys/net/ipv4/ip_forwardThis will enable it without a reboot.
NAT
iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADEWhat this does is make a NAT rule for post-routing. It sets the eth0 as the output card (The one out to the internet) and sets source to it's own IP through MASQUERADE. Then write: Just to be sure, save it.
iptables-save > /etc/iptables.rulesNow that it’s saved we need to load the iptables.rules on starting the network:
vi /etc/network/interfaces </source lang=cli>
- The extended interfaces
auto eth0 iface eth0 inet dhcp pre-up iptables-restore < /etc/iptables.rules post-down iptables-restore < /etc/iptables.rules </source> Test it out on your other client.