Difference between revisions of "Routing protocols"
From Teknologisk videncenter
m (added Category:Routing using HotCat) |
m (→OSPF highlights) |
||
| Line 35: | Line 35: | ||
|224.0.0.6 - Multicast to DR and BDR. DR will relay the information to DROthers on 224.0.0.5 | |224.0.0.6 - Multicast to DR and BDR. DR will relay the information to DROthers on 224.0.0.5 | ||
|- | |- | ||
| − | | rowspan= | + | | rowspan=4|Metric || Uses bandwidth called cost - Default calculated as 10<sup>8</sup> / bandwidth |
|- | |- | ||
| Metric is the accumulated cost to the destination network | | Metric is the accumulated cost to the destination network | ||
|- | |- | ||
|default highest bandwidth is 10<sup>8</sup> = 100 Mbps. Change with the '''auto-cost reference-bandwidth''' command. Remember to change on all routers. | |default highest bandwidth is 10<sup>8</sup> = 100 Mbps. Change with the '''auto-cost reference-bandwidth''' command. Remember to change on all routers. | ||
| + | |- | ||
| + | | Serial interfaces - Remember to set the '''bandwidth''' command on serial interfaces to reflect the actual clock rate. (1,544 Mbps or 128 Kbps default) | ||
|- | |- | ||
|} | |} | ||
[[Category:Routing]] | [[Category:Routing]] | ||
Revision as of 10:38, 25 April 2013
| Parameter | OSPF | EIGRP |
|---|---|---|
| Type | Link State | Distance vector |
| Metric | Bandwidth | Bandwidth + delay |
OSPF highlights
| Term | Explanation |
|---|---|
| Router-ID | Priority 1: Set with the router-id command |
| Priority 2: Highest loopback IP address | |
| Priority 3: Highest active interface IP address | |
| DR Designated Router | Priority 1: Highest priority. Set with the ip ospf priority command on the interface |
| Priority 2: Higest Router-ID | |
| BDR Backup Designated Router | Priority 1: Next highest priority. Set with the ip ospf priority command on the interface |
| Priority 2: Next higest Router-ID | |
| Communication | Uses multicast addresses 224.0.0.5 and 224.0.0.6 |
| 224.0.0.5 - Multicast to neighbours | |
| 224.0.0.6 - Multicast to DR and BDR. DR will relay the information to DROthers on 224.0.0.5 | |
| Metric | Uses bandwidth called cost - Default calculated as 108 / bandwidth |
| Metric is the accumulated cost to the destination network | |
| default highest bandwidth is 108 = 100 Mbps. Change with the auto-cost reference-bandwidth command. Remember to change on all routers. | |
| Serial interfaces - Remember to set the bandwidth command on serial interfaces to reflect the actual clock rate. (1,544 Mbps or 128 Kbps default) |