Difference between revisions of "Cisco 819G router/Cellular interface"
From Teknologisk videncenter
m (→Config) |
m |
||
Line 68: | Line 68: | ||
* - Default profile | * - Default profile | ||
</source> | </source> | ||
+ | ==Technology Auto as preferred== | ||
+ | <source lang=cli> | ||
+ | C819-Internet#<input>cellular 0 lte technology ?</input> | ||
+ | auto Automatic LTE Technology Selection | ||
+ | gsm GSM | ||
+ | lte LTE | ||
+ | umts UMTS | ||
+ | C819-Internet#<input>cellular 0 lte technology auto</input> | ||
+ | C819-Internet#<input>conf t</input> | ||
+ | Enter configuration commands, one per line. End with CNTL/Z. | ||
+ | C819-Internet(config)#<input>int cellular 0</input> | ||
+ | C819-Internet(config-if)#<input>no shut</input> | ||
+ | C819-Internet(config-if)#<input>int dialer 1</input> | ||
+ | C819-Internet(config-if)#<input>no shut</input> | ||
+ | </source> | ||
+ | <source lang=cli> | ||
+ | C819-Internet#<input>show cellular 0 radio</input> | ||
+ | Radio power mode = ON | ||
+ | Current RSSI(RSCP) = -72 dBm | ||
+ | LTE Technology Preference = AUTO | ||
+ | LTE Technology Selected = UMTS | ||
+ | </source> | ||
+ | <ource lang=cli> | ||
+ | C819-Internet#<input>show cellular 0 network</input> | ||
+ | Current Service Status = Normal | ||
+ | Current Service = Packet switched | ||
+ | Current Roaming Status = Home | ||
+ | Network Selection Mode = Automatic | ||
+ | Mobile Country Code (MCC) = 238 | ||
+ | Mobile Network Code (MNC) = 1 | ||
+ | Packet switch domain(PS) state = Attached | ||
+ | Registration(EMM) state = Registered | ||
+ | </source> | ||
+ | |||
+ | <source lang=cli> | ||
+ | C819-Internet#<input>ping 8.8.8.8</input> | ||
+ | Type escape sequence to abort. | ||
+ | Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds: | ||
+ | !!!!! | ||
+ | Success rate is 100 percent (5/5), round-trip min/avg/max = 96/107/140 ms | ||
+ | C819-Internet#<input>show cellular 0 profile</input> | ||
+ | Profile password Encryption level: 7 | ||
+ | |||
+ | Profile 1 = ACTIVE* | ||
+ | -------- | ||
+ | PDP Type = IPv4 | ||
+ | PDP address = 10.133.116.157 | ||
+ | Access Point Name (APN) = internet | ||
+ | Authentication = None | ||
+ | Username: | ||
+ | Password: 14 | ||
+ | Primary DNS address = 194.239.134.83 | ||
+ | Secondary DNS address = 193.162.153.164 | ||
+ | |||
+ | * - Default profile | ||
+ | </source> | ||
{{Source cli}} | {{Source cli}} |
Revision as of 08:10, 19 June 2014
Config
multilink bundle-name authenticated
chat-script lte "" "AT!CALL" TIMEOUT 20 "OK"
license udi pid C819G-4G-G-K9 sn FCZ181391HX
!
controller Cellular 0
!
interface Cellular0
ip address negotiated
ip nat outside
ip virtual-reassembly in
encapsulation slip
dialer in-band
dialer pool-member 1
!
interface Dialer1
ip address negotiated
ip access-group wan-in-3G in
ip nat outside
ip virtual-reassembly in
encapsulation slip
load-interval 30
dialer pool 1
dialer idle-timeout 0
dialer string gsm
dialer persistent
dialer-group 1
no snmp trap link-status
!
ip route 0.0.0.0 0.0.0.0 Dialer1
LTE as preferred
- SIM kort: Fra TDC USB modem
sh cellular 0 radio</input>
Radio power mode = ON
Current RSSI = -38 dBm
LTE Technology Preference = <notice>LTE</notice>
LTE Technology Selected = AUTO
C819-Internet#<input>sh cellular 0 network</input>
Current Service Status = <notice>No service</notice>
Current Service = Unknown
Current Roaming Status = Home
Network Selection Mode = Automatic
Mobile Country Code (MCC) = 238
Mobile Network Code (MNC) = 20
Packet switch domain(PS) state = Not attached
Registration(EMM) state = <notice>Registration Denied</notice>
C819-Internet#<input>show cellular 0 profile</input>
Profile password Encryption level: 7
Profile 1 = INACTIVE*
--------
PDP Type = IPv4
Access Point Name (APN) = internet
Authentication = None
Username:
Password: 14
* - Default profile
Technology Auto as preferred
C819-Internet#<input>cellular 0 lte technology ?</input>
auto Automatic LTE Technology Selection
gsm GSM
lte LTE
umts UMTS
C819-Internet#<input>cellular 0 lte technology auto</input>
C819-Internet#<input>conf t</input>
Enter configuration commands, one per line. End with CNTL/Z.
C819-Internet(config)#<input>int cellular 0</input>
C819-Internet(config-if)#<input>no shut</input>
C819-Internet(config-if)#<input>int dialer 1</input>
C819-Internet(config-if)#<input>no shut</input>
C819-Internet#<input>show cellular 0 radio</input>
Radio power mode = ON
Current RSSI(RSCP) = -72 dBm
LTE Technology Preference = AUTO
LTE Technology Selected = UMTS
<ource lang=cli> C819-Internet#<input>show cellular 0 network</input> Current Service Status = Normal Current Service = Packet switched Current Roaming Status = Home Network Selection Mode = Automatic Mobile Country Code (MCC) = 238 Mobile Network Code (MNC) = 1 Packet switch domain(PS) state = Attached Registration(EMM) state = Registered </source>
C819-Internet#<input>ping 8.8.8.8</input>
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 96/107/140 ms
C819-Internet#<input>show cellular 0 profile</input>
Profile password Encryption level: 7
Profile 1 = ACTIVE*
--------
PDP Type = IPv4
PDP address = 10.133.116.157
Access Point Name (APN) = internet
Authentication = None
Username:
Password: 14
Primary DNS address = 194.239.134.83
Secondary DNS address = 193.162.153.164
* - Default profile