Current configuration : 1179 bytes
!
! Last configuration change at 13:19:45 UTC Thu Dec 19 2019
version 15.2
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
!
no aaa new-model
!
!
ip cef
!
!
!
!
!
!
no ipv6 cef
!
!
license udi pid C881W-E-K9 sn FCZ175191GK
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
interface FastEthernet0
 no ip address
!
interface FastEthernet1
 no ip address
!
interface FastEthernet2
 no ip address
!
interface FastEthernet3
 no ip address
!
interface FastEthernet4
 no ip address
 duplex auto
 speed auto
!
interface Wlan-GigabitEthernet0
 description Internal switch interface connecting to the embedded AP
 no ip address
!
interface wlan-ap0
 description Embedded Service module interface to manage the embedded AP
 ip address 1.1.1.1 255.255.255.255
!
interface Vlan1
 no ip address
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
!
!
!
!
line con 0
 no modem enable
line aux 0
line 2
 no activation-character
 no exec
 transport preferred none
 transport input all
 stopbits 1
line vty 0 4
 login
 transport input all
!
scheduler allocate 20000 1000
!
end

 privilege 15 secret 0 <mypassword>
no username cisco

Replace <myuser> and <mypassword> with the username and password you want to
use. After you change your username/password you can turn off this message
by configuring  "no banner login" and "no banner exec" in privileged mode.

-----------------------------------------------------------------------
^C
banner login ^CC
% Password change notice.
-----------------------------------------------------------------------

Default username/password setup on AP is cisco/cisco with privilege level 15.
It is strongly suggested that you create a new username with privilege level
15 using the following command for console security.

username <myuser> privilege 15 secret 0 <mypassword>
no username cisco

Replace <myuser> and <mypassword> with the username and password you want to
use. After you change your username/password you can turn off this message
by configuring  "no banner login" and "no banner exec" in privileged mode.

-----------------------------------------------------------------------
^C
!
line con 0
 privilege level 15
 login local
 no activation-character
line vty 0 4
 login local
!
cns dhcp
end