Difference between revisions of "Errdisable Cisco IOS"
From Teknologisk videncenter
m (New page: To use Cisco IOS error disable feature you need to make sure what features are possible on the platform. <source lang=cli> PB1#show version <notice>Output omitted.........</notice> System ...) |
m (→BPDU guard) |
||
| Line 41: | Line 41: | ||
PB1(config)#<input>errdisable recovery interval 120</input> | PB1(config)#<input>errdisable recovery interval 120</input> | ||
PB1(config)#<input>int ran fa0/1 - 12</input> | PB1(config)#<input>int ran fa0/1 - 12</input> | ||
| − | PB1(config-if-range)#spanning-tree bpduguard enable | + | PB1(config-if-range)#<input>spanning-tree bpduguard enable</input> |
PB1(config)#<input><CTRL-Z></input> | PB1(config)#<input><CTRL-Z></input> | ||
PB1#show errdisable recovery | PB1#show errdisable recovery | ||
Revision as of 14:18, 21 March 2010
To use Cisco IOS error disable feature you need to make sure what features are possible on the platform.
PB1#show version
<notice>Output omitted.........</notice>
System image file is "flash:/c3550-ipservicesk9-mz.122-44.SE6.bin"
<notice>Output omitted.........</notice>
Model number: WS-C3550-24-EMI
<notice>Output omitted.........</notice>
PB1#<input>show errdisable recovery</input>
ErrDisable Reason Timer Status
----------------- --------------
arp-inspection Disabled
bpduguard Disabled
channel-misconfig Disabled
dhcp-rate-limit Disabled
dtp-flap Disabled
gbic-invalid Disabled
l2ptguard Disabled
link-flap Disabled
mac-limit Disabled
link-monitor-failure Disabled
loopback Disabled
oam-remote-failure Disabled
pagp-flap Disabled
port-mode-failure Disabled
psecure-violation Disabled
security-violation Disabled
sfp-config-mismatch Disabled
storm-control Disabled
udld Disabled
unicast-flood Disabled
vmps Disabled
Timer interval: 300 seconds
Interfaces that will be enabled at the next timeout:BPDU guard
PB1(config)#<input>errdisable recovery cause bpduguard</input>
PB1(config)#<input>errdisable recovery interval 120</input>
PB1(config)#<input>int ran fa0/1 - 12</input>
PB1(config-if-range)#<input>spanning-tree bpduguard enable</input>
PB1(config)#<input><CTRL-Z></input>
PB1#show errdisable recovery
ErrDisable Reason Timer Status
----------------- --------------
arp-inspection Disabled
bpduguard Enabled
channel-misconfig Disabled
<notice>Output omitted.........</notice>
Timer interval: 120 seconds
Interfaces that will be enabled at the next timeout: