Difference between revisions of "Switch port mirroring"
From Teknologisk videncenter
m (New page: Switch port mirroring is often used when sniffing traffic to/from a device. Se drawing below. {| | thumb|700px|left| Switch with port mirroring |}...) |
m (→Cisco Switch) |
||
| Line 7: | Line 7: | ||
Example below: Send a copy of traffic on fastethernet 0/1 to fastethernet 0/2. Traffic in both directions are mirrored. | Example below: Send a copy of traffic on fastethernet 0/1 to fastethernet 0/2. Traffic in both directions are mirrored. | ||
<source lang=cli> | <source lang=cli> | ||
| − | SW1# <input> | + | SW1# <input>configure terminal</input> |
| − | SW1(config)# <input> | + | SW1(config)# <input>monitor session 1 source fastethernet0/1</input> |
| − | SW1(config)# <input> | + | SW1(config)# <input>monitor session 1 destination fastethernet 0/2</input> |
</source> | </source> | ||
| Line 17: | Line 17: | ||
SW1(config)# <input>no MONITOR SESSION 1</input> | SW1(config)# <input>no MONITOR SESSION 1</input> | ||
</source> | </source> | ||
| + | |||
=Zyxel switch= | =Zyxel switch= | ||
Copy traffic from port 1,4,5 and 6 to port 3 | Copy traffic from port 1,4,5 and 6 to port 3 | ||
Revision as of 06:10, 29 September 2010
Switch port mirroring is often used when sniffing traffic to/from a device. Se drawing below.
Cisco Switch
Example below: Send a copy of traffic on fastethernet 0/1 to fastethernet 0/2. Traffic in both directions are mirrored.
SW1# <input>configure terminal</input>
SW1(config)# <input>monitor session 1 source fastethernet0/1</input>
SW1(config)# <input>monitor session 1 destination fastethernet 0/2</input>Remove mirror from session 1.
SW1# <input>CONFIGURE TERMINAL</input>
SW1(config)# <input>no MONITOR SESSION 1</input>Zyxel switch
Copy traffic from port 1,4,5 and 6 to port 3
Switch(config)# <input>mirror-port</input>
Switch(config)# <input>mirror-port 3</input>
Switch(config)# <input>interface port-channel 1,4-6</input>
Switch(config-interface)# <input>mirror</input>
Switch(config-interface)# <input>mirror dir egress</input>Remove mirror again
Switch(config)# <input>no mirror-port</input>