Difference between revisions of "IPTECH II RaEl/RIP øvelse"
From Teknologisk videncenter
m (Created page with "RIP - Routing Information Protocol - er en distance vector routing protokol der anvender HOP-count som metric. =Opgave= Der skal konfigureres RIP på alle routere vist i tegninge...") |
(No difference)
|
Revision as of 06:56, 20 June 2013
RIP - Routing Information Protocol - er en distance vector routing protokol der anvender HOP-count som metric.
Opgave
Der skal konfigureres RIP på alle routere vist i tegningen herunder.
- Download Packet tracer øvelse
Eksempel på konfiguration af RIP
På tegningen ovenfor ses det at Router1 har tre interfaces.
- Et interface i det logiske netværk 172.17.0.0/16
- Et interface i det logiske netværk 192.168.200.8/30
- Et interface i det logiske netværk 192.168.200.0/30
Router>
Router><input>ena</input>
Router#<input>conf t</input>
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#<input>router rip</input>
Router(config-router)#<input>version 2</input>
Router(config-router)#<input>network 172.17.0.0</input>
Router(config-router)#<input>network 192.168.200.8</input>
Router(config-router)#<input>network 192.168.200.0</input>
Router(config-router)#<input>exit</input>
Router(config)#<input>exit</input>
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#<input>copy run start</input>
Destination filename [startup-config]?
Building configuration...
[OK]
Router#