Difference between revisions of "Wired to Wireless bridge single SSID"
From Teknologisk videncenter
m (Created page with " <source lang=cli> Router#<input>conf t<input> Enter configuration commands, one per line. End with CNTL/Z. Router(config)#<input>int vlan 1<input> Router(config-if)#<input>ip a...") |
m |
||
Line 1: | Line 1: | ||
− | |||
<source lang=cli> | <source lang=cli> | ||
− | Router#<input>conf t<input> | + | Router#<input>conf t</input> |
Enter configuration commands, one per line. End with CNTL/Z. | Enter configuration commands, one per line. End with CNTL/Z. | ||
− | Router(config)#<input>int vlan 1<input> | + | Router(config)#<input>int vlan 1</input> |
Router(config-if)#<input>ip address 192.168.64.4 255.255.255.0<input> | Router(config-if)#<input>ip address 192.168.64.4 255.255.255.0<input> | ||
Router(config-if)#<input>interface wlan-ap0<input> | Router(config-if)#<input>interface wlan-ap0<input> |
Revision as of 08:56, 15 June 2014
Router#<input>conf t</input>
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#<input>int vlan 1</input>
Router(config-if)#<input>ip address 192.168.64.4 255.255.255.0<input>
Router(config-if)#<input>interface wlan-ap0<input>
The wlan-ap 0 interface is used for managing the embedded AP.
Please use the "service-module wlan-ap 0 session" command to console into the embedded AP
Router(config-if)#<input>ip unnumbered vlan 1<input>
Router(config-if)#<input>no shutdown<input>
Router(config-if)#<input>^Z<input>
Router#
*Jun 15 07:56:51.767: %SYS-5-CONFIG_I: Configured from console by consoleshow
Router#<input>show ip interface brief<input>
Interface IP-Address OK? Method Status Protocol
ATM0 unassigned YES unset administratively down down
Ethernet0 unassigned YES unset administratively down down
GigabitEthernet0 unassigned YES unset up up
GigabitEthernet1 unassigned YES unset down down
GigabitEthernet2 unassigned YES unset down down
GigabitEthernet3 unassigned YES unset down down
GigabitEthernet4 unassigned YES unset down down
GigabitEthernet5 unassigned YES unset down down
GigabitEthernet6 unassigned YES unset down down
GigabitEthernet7 unassigned YES unset down down
GigabitEthernet8 unassigned YES unset administratively down down
Vlan1 192.168.64.4 YES manual up up
Wlan-GigabitEthernet8 unassigned YES unset up up
wlan-ap0 192.168.64.4 YES TFTP up up