Difference between revisions of "Wired to Wireless bridge single SSID"
From Teknologisk videncenter
m |
m |
||
| Line 14: | Line 14: | ||
</source> | </source> | ||
==Check interface status== | ==Check interface status== | ||
| + | <source> | ||
Router#<input>show ip interface brief</input> | Router#<input>show ip interface brief</input> | ||
Interface IP-Address OK? Method Status Protocol | Interface IP-Address OK? Method Status Protocol | ||
Revision as of 10:05, 15 June 2014
Basic interface configuration
Configure VLAN 1 with an IP address and associate wlan-ap0 with it.
Router#<input>conf t</input>
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#<input>int vlan 1</input>
Router(config-if)#<input>ip address 192.168.64.4 255.255.255.0</input>
Router(config-if)#<input>interface wlan-ap0</input>
The wlan-ap 0 interface is used for managing the embedded AP.
Please use the "service-module wlan-ap 0 session" command to console into the embedded AP
Router(config-if)#<input>ip unnumbered vlan 1</input>
Router(config-if)#<input>no shutdown</input>Check interface status
Router#<input>show ip interface brief</input>
Interface IP-Address OK? Method Status Protocol
ATM0 unassigned YES unset administratively down down
Ethernet0 unassigned YES unset administratively down down
GigabitEthernet0 unassigned YES unset up up
GigabitEthernet1 unassigned YES unset down down
GigabitEthernet2 unassigned YES unset down down
GigabitEthernet3 unassigned YES unset down down
GigabitEthernet4 unassigned YES unset down down
GigabitEthernet5 unassigned YES unset down down
GigabitEthernet6 unassigned YES unset down down
GigabitEthernet7 unassigned YES unset down down
GigabitEthernet8 unassigned YES unset administratively down down
Vlan1 <notice>192.168.64.4</notice> YES manual up up
Wlan-GigabitEthernet8 unassigned YES unset up up
wlan-ap0 <notice>192.168.64.4</notice> YES TFTP up upSetup the access point part 1
The access point - AP -wlan-ap0 is a built in service module running its own IOS. To connect to the AP use the service-module command from the Routers IOS. =Connecting