Wired to Wireless bridge single SSID

From Teknologisk videncenter
Revision as of 10:05, 15 June 2014 by Heth (talk | contribs)
Jump to: navigation, search

Basic interface configuration

Configure VLAN 1 with an IP address and associate wlan-ap0 with it. 

Router#<input>conf t</input>
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#<input>int vlan 1</input>
Router(config-if)#<input>ip address 192.168.64.4 255.255.255.0</input>
Router(config-if)#<input>interface wlan-ap0</input>
The wlan-ap 0 interface is used for managing the embedded AP.
Please use the "service-module wlan-ap 0 session" command to console into the embedded AP

Router(config-if)#<input>ip unnumbered vlan 1</input>
Router(config-if)#<input>no shutdown</input>

Check interface status

Router#<input>show ip interface brief</input> Interface IP-Address OK? Method Status Protocol ATM0 unassigned YES unset administratively down down Ethernet0 unassigned YES unset administratively down down GigabitEthernet0 unassigned YES unset up up GigabitEthernet1 unassigned YES unset down down GigabitEthernet2 unassigned YES unset down down GigabitEthernet3 unassigned YES unset down down GigabitEthernet4 unassigned YES unset down down GigabitEthernet5 unassigned YES unset down down GigabitEthernet6 unassigned YES unset down down GigabitEthernet7 unassigned YES unset down down GigabitEthernet8 unassigned YES unset administratively down down Vlan1 <notice>192.168.64.4</notice> YES manual up up Wlan-GigabitEthernet8 unassigned YES unset up up wlan-ap0 <notice>192.168.64.4</notice> YES TFTP up up </source>

Setup the access point part 1

The access point - AP -wlan-ap0 is a built in service module running its own IOS. To connect to the AP use the service-module command from the Routers IOS. =Connecting


Retrieved from "http://mars.merhot.dk/w/index.php?title=Wired_to_Wireless_bridge_single_SSID&oldid=27646"