Cisco 3560 IPv6

• See Cisco TCAM for more info on SDM and TCAM

SDM setting

Check SDM setting

As seen below. No IPv6 entries possible in template "Desktop Routing".

Heimdal#<input>sh sdm prefer</input>
 The current template is "desktop routing" template.
 The selected template optimizes the resources in
 the switch to support this level of features for
 8 routed interfaces and 1024 VLANs.

  number of unicast mac addresses:                  3K
  number of IPv4 IGMP groups + multicast routes:    1K
  number of IPv4 unicast routes:                    11K
    number of directly-connected IPv4 hosts:        3K
    number of indirect IPv4 routes:                 8K
  number of IPv4 policy based routing aces:         512
  number of IPv4/MAC qos aces:                      512
  number of IPv4/MAC security aces:                 1K

Check preferred

Below is what we want for IP dual-stack operation. Hard to see TCAM utilization on this IOS/Platform. Do not support the show platform tcam utilization command.

Heimdal#<input>sh sdm prefer dual-ipv4-and-ipv6 default</input>
 "desktop IPv4 and IPv6 default" template:
 The selected template optimizes the resources in
 the switch to support this level of features for
 8 routed interfaces and 1024 VLANs.

  number of unicast mac addresses:                  2K
  number of IPv4 IGMP groups + multicast routes:    1K
  number of IPv4 unicast routes:                    3K
    number of directly-connected IPv4 hosts:        2K
    number of indirect IPv4 routes:                 1K
  number of IPv6 multicast groups:                  1K
  number of directly-connected IPv6 addresses:      2K
  number of indirect IPv6 unicast routes:           1K
  number of IPv4 policy based routing aces:         0
  number of IPv4/MAC qos aces:                      512
  number of IPv4/MAC security aces:                 1K
  number of IPv6 policy based routing aces:         0
  number of IPv6 qos aces:                          510
  number of IPv6 security aces:                     510

Changing to new SDM profile

Heimdal#<input>conf t</input>
Enter configuration commands, one per line.  End with CNTL/Z.
Heimdal(config)#<input>sdm prefer dual-ipv4-and-ipv6 default</input>
Changes to the running SDM preferences have been stored, but cannot take effect
until the next reload.
Use 'show sdm prefer' to see what SDM preference is currently active.
Heimdal(config)#<input>reload</inpur>