Cisco 881W wireless bridge
From Teknologisk videncenter
Router
Current configuration : 1179 bytes
!
! Last configuration change at 13:19:45 UTC Thu Dec 19 2019
version 15.2
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
!
no aaa new-model
!
!
ip cef
!
!
!
!
!
!
no ipv6 cef
!
!
license udi pid C881W-E-K9 sn FCZ175191GK
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
interface FastEthernet0
no ip address
!
interface FastEthernet1
no ip address
!
interface FastEthernet2
no ip address
!
interface FastEthernet3
no ip address
!
interface FastEthernet4
no ip address
duplex auto
speed auto
!
interface Wlan-GigabitEthernet0
description Internal switch interface connecting to the embedded AP
no ip address
!
interface wlan-ap0
description Embedded Service module interface to manage the embedded AP
ip address 1.1.1.1 255.255.255.255
!
interface Vlan1
no ip address
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
!
!
!
!
line con 0
no modem enable
line aux 0
line 2
no activation-character
no exec
transport preferred none
transport input all
stopbits 1
line vty 0 4
login
transport input all
!
scheduler allocate 20000 1000
!
end
Wireless
privilege 15 secret 0 <mypassword>
no username cisco
Replace <myuser> and <mypassword> with the username and password you want to
use. After you change your username/password you can turn off this message
by configuring "no banner login" and "no banner exec" in privileged mode.
-----------------------------------------------------------------------
^C
banner login ^CC
% Password change notice.
-----------------------------------------------------------------------
Default username/password setup on AP is cisco/cisco with privilege level 15.
It is strongly suggested that you create a new username with privilege level
15 using the following command for console security.
username <myuser> privilege 15 secret 0 <mypassword>
no username cisco
Replace <myuser> and <mypassword> with the username and password you want to
use. After you change your username/password you can turn off this message
by configuring "no banner login" and "no banner exec" in privileged mode.
-----------------------------------------------------------------------
^C
!
line con 0
privilege level 15
login local
no activation-character
line vty 0 4
login local
!
cns dhcp
end