GPS RECEIVER - MT3329

From Teknologisk videncenter
Revision as of 12:47, 10 December 2013 by Heth (talk | contribs) (Module on MCBSTM32C Keil board)
Jump to: navigation, search

Module on MCBSTM32C Keil board

Picture 1: GPS Module attached to Keil board. (Click to enlarge)
Picture 2: Wires attached between Keil board and 6 pin connecter. (Click to enlarge)
Picture 3: GPS Module attached to 6 pin connector on Keil board. (Click to enlarge)

Using the STM32F107VC remapped USART1 to PB6 (USART1_TX)and PB7 (USART1_RX).

  • The [1] show that PB6 is used for CAN2 bus TX. CAN2 bus can't be used at the same time as the GPS module.
  • The [2] show that PB7 is used for the USER button. To use PB7 as RX from the GPS module it is necessary to remove C20. The USER switch can't be used at the same time as the GPS module.

Battery connector on keil board

The minus pole on the battery has no electrical connection to the main board. To make a connection a desisolated wire was placed between the minuspole on the battery and the goldplated area on the PCB under the battery. See picture 2.

Connections

Solder a 6 pin 0,1 inch 90 degrees angle. See picture 2 and connect

  • Pin 1 to 3,3V (Red wire)
  • Pin 2 to GND (Black wire)
  • Pin 3 - Not used in this project ( 1 second pulse signal from GPS module )
  • Pin 4 to PB7 (Orange wire) - GPS module TX
  • Pin 5 to PB6 (Yellow wire) - GPS module RX
  • Pin 6 - NOt used in this project ( FIX signal )

Data sheets

ARM board projects


Links