Wired to Wireless bridge single SSID

Basic interface configuration

Configure VLAN 1 with an IP address and associate wlan-ap0 with it.

Router#<input>conf t</input>
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#<input>int vlan 1</input>
Router(config-if)#<input>ip address 192.168.64.4 255.255.255.0</input>
Router(config-if)#<input>interface wlan-ap0</input>
The wlan-ap 0 interface is used for managing the embedded AP.
Please use the "service-module wlan-ap 0 session" command to console into the embedded AP

Router(config-if)#<input>ip unnumbered vlan 1</input>
Router(config-if)#<input>no shutdown</input>

Check interface status

Router#<input>show ip interface brief</input>
Interface                  IP-Address      OK? Method Status                Protocol
ATM0                       unassigned      YES unset  administratively down down
Ethernet0                  unassigned      YES unset  administratively down down
GigabitEthernet0           unassigned      YES unset  up                    up
GigabitEthernet1           unassigned      YES unset  down                  down
GigabitEthernet2           unassigned      YES unset  down                  down
GigabitEthernet3           unassigned      YES unset  down                  down
GigabitEthernet4           unassigned      YES unset  down                  down
GigabitEthernet5           unassigned      YES unset  down                  down
GigabitEthernet6           unassigned      YES unset  down                  down
GigabitEthernet7           unassigned      YES unset  down                  down
GigabitEthernet8           unassigned      YES unset  administratively down down
Vlan1                      <notice>192.168.64.4</notice>    YES manual up                    up
Wlan-GigabitEthernet8      unassigned      YES unset  up                    up
wlan-ap0                   <notice>192.168.64.4</notice>    YES TFTP   up                    up

Setup the access point part 1

The access point - AP -wlan-ap0 is a built in service module running its own IOS. To connect to the AP use the service-module command from the Routers IOS. =Connecting