Difference between revisions of "3-tier design/NATConfig"
From Teknologisk videncenter
m (Created page with "<source lang=cli> HQFW1#<input>conf t</input> Enter configuration commands, one per line. End with CNTL/Z. HQFW1(config)#<input>ip access-list extended NAT_ACL</input> HQFW1(co...") |
m |
||
| Line 15: | Line 15: | ||
HQFW1(config-if)#<input>interface fastethernet 0/1</input> | HQFW1(config-if)#<input>interface fastethernet 0/1</input> | ||
HQFW1(config-if)#<input>ip nat inside</input></source> | HQFW1(config-if)#<input>ip nat inside</input></source> | ||
| + | {{Source cli}} | ||
Latest revision as of 16:44, 2 June 2015
HQFW1#<input>conf t</input>
Enter configuration commands, one per line. End with CNTL/Z.
HQFW1(config)#<input>ip access-list extended NAT_ACL</input>
HQFW1(config-ext-nacl)#<input>permit ip 172.16.0.0 0.0.255.255 any</input>
HQFW1(config-ext-nacl)#<input>permit ip 172.17.0.0 0.0.255.255 any</input>
HQFW1(config-ext-nacl)#<input>permit ip 172.18.0.0 0.0.255.255 any</input>
HQFW1(config-ext-nacl)#<input>exit</input>
HQFW1(config)#<input>ip nat inside source list NAT-ACL interface ethernet 0/0/0 overload</input>
HQFW1(config)#<input>interface ethernet 0/0/0</input>
HQFW1(config-if)#<input>ip nat outside</input>
HQFW1(config-if)#<input>exit</input>
HQFW1(config)#<input>interface fastethernet 0/0</input>
HQFW1(config-if)#<input>ip nat inside</input>
HQFW1(config-if)#<input>interface fastethernet 0/1</input>
HQFW1(config-if)#<input>ip nat inside</input>