Mdp ccnp 1

CCNP 1

Ospf Challange Lab Noter

Hvis man skal lave en restribute mellem OSPF og EIGRP, skal man sætte en default metric på EIGRP siden. Kommandoen man skal bruge ser sådan ud:

router eigrp 65000
 redistribute ospf 1 metric 1000 10 255 255 1500

IS-IS Noter

IS-IS and OSPF are more similar than dissimilar. Both routing protocols have the following characteristics:

• Open-standard link-state routing protocols
• Support VLSM
• Support route summarization between areas
• Similar mechanisms to maintain the health of the LSDB (link-state advertisements [LSAs], link-state aging timers,and LSDB synchronization)
• Use the shortest path first (SPF) algorithm, with similar update, decision, and flooding processes
• Successful in the largest and most demanding ISP networks
• Converge quickly after network changes

The basic setup of IS-IS requires four steps.

• Step 1 Map out the areas, plan the addressing, and determine which interfaces are to participate in the IS-IS routing process.
• Step 2 Enable IS-IS on the router with the router isis global configuration command.
• Step 3 Configure the NET address with the net router configuration command.
• Step 4 Enable Integrated IS-IS on the appropriate interfaces with the ip router isis interface configuration command.

Commands to do this

router isis [area-tag] enable isis as an IP routing protocol and assigns a tag to the process (optional). Given in global 
configuration mode.

net network-entity-title Identifies the router for isis by assigning a net to the router. Given in global configuration mode.

Ip router isis [area-tag] enable isis on the interface that run isis (this approach is slightly different than most IP routing protocols,
where the interface are defined by network statements; there is no network statement under the isis process.) Given in interface 
configuration mode.