Difference between revisions of "3-tier design"
From Teknologisk videncenter
m (→Campus Configuration) |
m (→Campus Configuration) |
||
Line 14: | Line 14: | ||
##Configure ip addresses on all routed ports [[/routerIPs|Config]]/[[Cisco_basic_configuration/en|Info]] | ##Configure ip addresses on all routed ports [[/routerIPs|Config]]/[[Cisco_basic_configuration/en|Info]] | ||
##Configure ip addresses on all SVI interfaces [[/SVIIPs|Config]] | ##Configure ip addresses on all SVI interfaces [[/SVIIPs|Config]] | ||
− | #Configure VTP configuration | + | #Configure VTP configuration [[CCNA_Explorer_3_VTP|Info]] |
##The distribution switches should be VTP Servers [[/VTPServers|Config]] | ##The distribution switches should be VTP Servers [[/VTPServers|Config]] | ||
##The Access Switches should be VTP Clients [[/VTPClinets|Config]] | ##The Access Switches should be VTP Clients [[/VTPClinets|Config]] |
Revision as of 10:16, 12 November 2014
Setup
We are going to configure the following 3-tier design in steps
Download the setup as a PDF
Campus Configuration
Configure the campus core and the 2 distribution blocks with OSPF and the other needed protocols.
- Configure Hostnames on all devices in the Campus Config/Info
- Configure IP addresses on all devices
- Configure VTP configuration Info
- Configure Distribution Switch 1 to be the STP Master for alle PVST+ instances Config/Info
- Configure HSRP on all SVI interfaces Config/Info
- Configure Etherchannel between the distibution switches Config/Info
- Configure trunk ports between the Distribution and Access Switches Config/Info
- Configure the access switches with an ip address in the MGMT VLAN Config
- Configure ports for the clients Config/Info
- Configure OSPF Info
- Configure OSPF area 0 on all interconnects
- Configure OSPF area 1/2 on the distribution blocks
- Do Not use stub areas