Revision as of 11:32, 12 November 2014

Setup

We are going to configure the following 3-tier design in steps

Setup

Download the setup as a PDF

Campus Configuration

Configure the campus core and the 2 distribution blocks with OSPF and the other needed protocols.

Campus

1. Configure Hostnames on all devices in the Campus Config/Info
2. Configure IP addresses on all devices
   1. Configure ip addresses on all routed ports Config/Info
   2. Configure ip addresses on all SVI interfaces Config
3. Configure VTP configuration Info
   1. The distribution switches should be VTP Servers Config
   2. The Access Switches should be VTP Clients Config
   3. The VTP Domain and password should be different in each block Config
4. Configure Distribution Switch 1 to be the STP Master for alle PVST+ instances Config/Info
5. Configure HSRP on all SVI interfaces Config/Info
6. Configure Etherchannel between the distibution switches Config/Info
7. Configure trunk ports between the Distribution and Access Switches Config/Info
8. Configure the access switches with an ip address in the MGMT VLAN Config
9. Configure ports for the clients Config/Info
10. Configure OSPF Info
    1. Configure OSPF area 0 on all interconnects Config
    2. Configure OSPF area 1/2 on the distribution blocks
    3. Do Not use stub areas
11. Configure a static default route on HQFW01 point to 80.112.80.1
12. Redistribute the defualt route into OSPF Config
13. Configure NAT/PAT on HQFW01 Info

Branch Configuration

Branches

1. Add another ethernet interface to the HQFW01 Router
2. Configure the internet as a norman Layer 2 switch
3. Configure the Branch 1 equipment
   1. Configure IP addresses on all devices
   2. Configure SVI interfaces for the user LANs
4. Configure tunnel interfaces to connect the Branch with HQ Config