Difference between revisions of "VLAN Trunk Cisco IOS"
From Teknologisk videncenter
m |
m (→Configuring a Trunk port) |
||
| Line 5: | Line 5: | ||
A VLAN trunk is a connection between two switches where traffic from one or more VLAN's are transmitted between switches. | A VLAN trunk is a connection between two switches where traffic from one or more VLAN's are transmitted between switches. | ||
[[image:VLAN trunk.png|thumb|400px|none|Trunk between two switches carrying traffic from VLAN 100 and VLAN 200 between the Switches]] | [[image:VLAN trunk.png|thumb|400px|none|Trunk between two switches carrying traffic from VLAN 100 and VLAN 200 between the Switches]] | ||
| − | =Configuring | + | =Configuring Trunk ports= |
| − | + | == Basic Cisco 2950 and 2960 switch configuration == | |
| − | |||
Cisco 2950 and 2960 switch series only supports the 802.1Q - DOT1Q - trunk protocol. | Cisco 2950 and 2960 switch series only supports the 802.1Q - DOT1Q - trunk protocol. | ||
<pre> | <pre> | ||
| Line 13: | Line 12: | ||
SW2(config-if)#switchport mode trunk | SW2(config-if)#switchport mode trunk | ||
</pre> | </pre> | ||
| − | + | == Basic Cisco 3550 and 3560 switch configuration == | |
Cisco 3550 and 3560 switch series supports the 802.1Q - DOT1Q - and Cisco ISL trunk protocols. | Cisco 3550 and 3560 switch series supports the 802.1Q - DOT1Q - and Cisco ISL trunk protocols. | ||
<pre> | <pre> | ||
| Line 20: | Line 19: | ||
H4S1(config-if)#switchport mode trunk | H4S1(config-if)#switchport mode trunk | ||
</pre> | </pre> | ||
| + | = IEEE 802.1Q trunk protocol = | ||
| + | The [[IEEE 802.1Q]] is a trunk protocol defined by [[IEEE]]. See the related articles. | ||
[[Category:Cisco]][[Category:CCNA]][[Category:CCNP]][[Category:IOS]][[Category:Network]][[Category:CCNP3]] | [[Category:Cisco]][[Category:CCNA]][[Category:CCNP]][[Category:IOS]][[Category:Network]][[Category:CCNP3]] | ||
Revision as of 07:40, 28 April 2009
Contents
Configuring a trunk port
Cisco materials
VLAN trunks
A VLAN trunk is a connection between two switches where traffic from one or more VLAN's are transmitted between switches.
Configuring Trunk ports
Basic Cisco 2950 and 2960 switch configuration
Cisco 2950 and 2960 switch series only supports the 802.1Q - DOT1Q - trunk protocol.
SW2(config)#interface gigabitEthernet 0/1 SW2(config-if)#switchport mode trunk
Basic Cisco 3550 and 3560 switch configuration
Cisco 3550 and 3560 switch series supports the 802.1Q - DOT1Q - and Cisco ISL trunk protocols.
H4S1(config)#int fastEthernet 0/24 H4S1(config-if)#switchport trunk encapsulation dot1q H4S1(config-if)#switchport mode trunk
IEEE 802.1Q trunk protocol
The IEEE 802.1Q is a trunk protocol defined by IEEE. See the related articles.